Amerex 05607 Bedienungsanleitung PDF herunterladen (Seite 5)

11. Install ring pin with ring facing front of the extinguisher. Install new tamper seal. Record

recharge date and attach new recharge tag.

12. Weigh assembled extinguisher and confirm that the total weight is within the allowable

tolerances indicated in the Maintenance section on the extinguisher nameplate (label).

TROUBLESHOOTING GUIDE

WARNING: Determine the source of a leak before the extinguisher is depressurized. THE

EXTINGUISHER MUST BE COMPLETELY DEPRESSURIZED BEFORE ANY ATTEMPT IS MADE TO

DEVALVE IT AND CORRECT ANY LEAKAGE PROBLEM. To depressurize – hold the extinguisher in

an inverted position and slowly squeeze the discharge handle. Some liquid remaining in the downtube

will be discharged so care should be taken in the area used for depressurization. Thoroughly clean all

valve parts after depressurization and valve removal.

PROBLEM

CORRECTIVE ACTION

Leak at collar o-ring

Remove valve assembly, clean collar (knurled) nut thoroughly

and install new o-ring. Lubricate the o-ring with Visilox V-711

(P/N 06247).

Leak through valve

Install new valve stem assembly. Check valve seat for

scratches or foreign matter.

Leak around gauge

threads

Remove gauge* and reinstall using Teflon tape on the gauge

threads.

Defective gauge

Remove defective gauge* and install a new gauge using

Teflon tape on the gauge threads.

Leak in the cylinder

Contact Amerex if under warranty, otherwise mark "Rejected"

and return to owner.

Broken footstand

Install new footstand (see parts list)

Pressure gauge threads are coated with a special epoxy at the factory. For easy

removal soak the valve assembly (minus the downtube assembly) in hot water

(180°F/82°C) for two to four minutes. Remove gauge with a 7/16” open end wrench.

1 2 3 4 5 6

Keine Kommentare

Amerex 05607 Bedienungsanleitung Seite 5